DS90LV001 enable

Mass Garp

Other Parts Discussed in Thread: DS90LV001

Hi,

How could I drive the Enable in DS90LV001?

What can happen if Ieave it unconnected?

Thanks

0 John Goldie over 13 years ago

Greetings -

The EN pin turns on and off the output driver of the device. To enable the driver, you need to drive this pin to a HIGH logic level (>2V).

Do not float this pin. It you always want it on, suggest a 10k pull up to VCC rail on that pin.

John Goldie

Video Interface - DPS / SVA

0 Mass Garp over 13 years ago in reply to John Goldie

Ok.

Very grateful!

Interface forum