Value of configuration pins (TUSB1310) PHY_MODE1/PHY_MODE0

SudArt Art

In datasheet:

PHY_MODE1 - Must be set to 0. Operates as USB 3.0 transceiver.
PHY_MODE0 - Must be set to 1. Operates as USB 3.0 transceiver.

But what values must I set it, if I would like work with USB 2.0?

over 13 years ago

0 Elias Villegas M. over 13 years ago

TI__Guru* 76130 points

Hello,

The only supported mode is to set PHY_MODE1=0 and PHY_MODE0=1, in this configuration you will be able to use the transceiver in both USB 3.0 with the PIPE interface and USB 2.0 mode with the ULPI interface.

Regards.

Interface

Interface forum

Value of configuration pins (TUSB1310) PHY_MODE1/PHY_MODE0