DS25BR110 / tolerance of Rin,Rout

Ryuji

Guru 20090 points

Other Parts Discussed in Thread: DS25BR110

Hello,

Internal termination Resistor Rin/Rout has typical value(100ohm) only.

I would like to know the tolerance of Rin/Rout.
Could you please kindly let me know the tolerance of Rin/Rout?

I understood reference data is not guaranteed due to there is not datahseet.

So, please let me know it for my reference.

Best Regards,
Ryuji Asaka

0 Ryuji over 12 years ago

Guru 20090 points

Hello team,

Sorry for bothering you.

Are there any information of the Rin/Rout tolerance ?

Best Regards,

Ryuji Asaka

0 Ryuji over 12 years ago in reply to Ryuji

Guru 20090 points

Hello,

Could I have the comment please ?

If there is no data about Rin/Rout tolerance , please let me know it.

Best Regards,
Ryuji Asaka

0 T.K. Chin over 12 years ago in reply to Ryuji

Hi Ryuji,

My apology for the late reply.

The RIN and ROUT in the DS of DS25BR110 is shown as 100 ohm typical. The on-chip termination resistors usually have a tolerance of +-20%.

regards,

TK Chin

Interface forum