DS110DF410 - ADR 0x09 value in PRBS Mode

Kawai

Guru 19785 points

Other Parts Discussed in Thread: DS110DF410

There seems to have a typo in the DS110DF410 datasheet middle of page32. There is a following description.

"Notice that when this entire sequence has been completed, bits7:2 of register 0x09 will all be set."

I have tested with my EVM but I only found ADR 0x09 = 0xEC = 8'b11101100, when PRBS is ON.

Is this correct operation ?

Best Regards,
Kawai

over 12 years ago

0 Nasser Mohammadi over 12 years ago

TI__Guru* 93570 points

Hi Kawai-San,

I am looking into this now and will let you know.

Regards,,nasser

0 Lee Sledjeski over 12 years ago

TI__Mastermind 43795 points

Kawai-san,

I have read through the DS110DF410 datasheet section on PRBS generation. The value of Reg 0x09 on the EVM is correct. During the PRBS programming sequence only bits [7], [6], [5], [3], and [2] are set to Logic 1. Bit [4] remains at Logic 0.

Regards,

Lee

0 Kawai over 12 years ago in reply to Lee Sledjeski

Guru 19785 points

Lee-san, Nasser-san,

Thank you very much for your support.

I am asked from several customer about this datasheet description. Please modify this typo description at the next datasheet revision changing timing.

Thanks and Best Regards,
Kawai

Interface

Interface forum

DS110DF410 - ADR 0x09 value in PRBS Mode