To make sure that using DS90UB925/926 and TFP401

Jin Kim

Other Parts Discussed in Thread: TFP401

I'm considering to use as like below

DVI -> TFP401(2-pixel mode) -> DS90UB925 x 2 -> DS90UB926 x 2

I think it would be possible. but, I'm afraid how to connect the signals like clock and HSYNC, VSYNC.

Is there a recommendation for this application?

0 Michael Peffers over 12 years ago

Hi Jin,

Sorry for the delay in response, somebody is looking into this though and will respond shortly.

Regards,

Michael Peffers

Analog Application Engineer

0 Jin Kim over 12 years ago in reply to Michael Peffers

Hi Michael

thanks for the reply on my query.

Anyway hope to see prompt answer.

0 Mark Sauerwald88474 over 12 years ago in reply to Jin Kim

Jin

I would connect H and V in parallel to both '925s, and use those signals at the output of the '926s to re-synchronize the two data paths.

Mark Sauerwald

0 Jin Kim over 12 years ago in reply to Mark Sauerwald88474

Hi Mark.

Do you mean that I can connect Hsync and Vsync, PCLK in parallel to both 925s without problem?

Interface forum