• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 33 subscribers
  • Views 468 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

LMH0387 - HEX data for LMH0387 SPA Dongle

Kawai
Guru 19785 points

Other Parts Discussed in Thread: LMH0387, DS110DF410, ALP

Hi Team,

I have had programmed my SPA dongle to use to interface DS110DF410. I think I need to reprogram the SPA dongle HEX data to use with LMH0387.

Where can you find this HEX data ?

Thanks in advance.

Best Regards,
Kawai

  • 0
    TI__Genius 13475 points

     

    The dongle is programmed in two steps - first is the basic code for the dongle, which involves the FLIP program and the hex file, which you probably do not need, and the second is a short sequence which identifies which part you are using to the ALP program.

    If you plug the dongle into your computer and start the ALP program, and it comes up showing the DS110DF410 GUI, then all you need to do is to reprogram the identification sequence to do this, start ALP, and on the left hand side you will a section for 'tools' - expand this, and select the EEPROM Setup option.

    When this opens, on the leftmost pane, you should see something that says 'Select Device', and under that it should have found the 'ALP NANO' and under that, you will see your board identified (as the DS110DF410)  - select this.

    In the next pane, 'Select Profile' select the profile for the LMH0387, and then click 'Write EEPROM' and this will reconfigure the SPA Dongle for you.

     If the ALP program does not recognize the SPA dongle at all, then you will need to first program the Dongle with the HEX file, please reply to this message is that is the case.