DS90UB913A/914A - Power over cable spec

Kawai

Guru 19785 points

Hi team,

Could you please tell me the maximum voltage and current which could be designed for power over cable, power feeding from 914A to 913A?

Best Regards,

Kawai

0 Mark Sauerwald88474 over 11 years ago

Kawai

There is an application note - SNLA224 available on the 913A product page that describes the POC constraints:

0 Kawai over 11 years ago in reply to Mark Sauerwald88474

Guru 19785 points

Hi Mark-san,

I knew about the application note about POC.

Regarding your answer in the following post, I understood it would depend on the inductor characteristics.

Also limited to connector or cable specification.

http://e2e.ti.com/support/interface/high_speed_interface/f/138/p/359563/1263524.aspx#1263524

Best Regards,
Kawai

Interface forum