Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

  • State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 33 subscribers
  • Views 2206 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TCA9546APWR Testing with Total Phase Aardvark

Ali Tatari27
Prodigy 40 points
Other Parts Discussed in Thread: TCA9546A

Hi,

I am trying to test TCA9546 functionality on my board using total phase aardvark. I2C is from a processor which is multiplexed by TCA9546A . I am unable to test or change register settings with using Aardvark. what would be the procedure? Please help. 

  • 0
    TI__Expert 6430 points
    Hi, Could you please post reset signal waveform?Thanks
  • 0
    TI__Mastermind 30280 points

    Does the Aardvark have internal pull-up resistors on SDA and SCL?

    If so, what is their value?

    If not, then that is your problem, because I do not see any pull-up resistors on SDA/SCL in your schematic.

    Please provide us the data log from the Aardvark if you have checked the pull-up resistors and verified the values. 

    Make sure the slave address is shown somewhere.

    Also, please provide scope shots clearly displaying SDA and SCL for a full Read or Write command (9 bits for the Slave Address and ACK, and 9 bits for the data and ACK).