• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 33 subscribers
  • Views 621 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS90C187 / OA_3+/- and OB_3+/- connection at Dual Pixel 18bpp

S.Satoshi
Guru 21685 points

Other Parts Discussed in Thread: DS90C187

Hi Everyone,

Our customer plan to use DS90C187 with Single in Dual out 18bpp. Then please let me know the connection of OA_3+/- and OB_3+/- output. Can they leave open?

Best Regards,

Sonoki / Japan Disty

  • 0
    TI__Guru* 93570 points
    Hi Satoshi-San,

    Please note figure 16 of the data sheet. In this mode, dual pixel 18 bpp, OA3 and OB3 are tri-stated. If these pins are not going to a connector or there is no trace on these pins then you can make them no connect. But if they go to a connector or there is trace on these pins then please use 100 Ohm resistor between plus and minus of OA and OB signals to terminate these pins.

    Regards,,nasser