TUSB9261 / HID communication

TI TUSB

Other Parts Discussed in Thread: TUSB9261

Hello,

i have a TUSB9261 demo board for evaluatiopn purposes and im currently stuck at reading the button "SW1". I figured out the button doesnt send any interrupts nor modifies the input report without any poll / command.

My question: is there any documentation or guide for using the HID part of the demo board (aside from the HID commands for uploading firmware)?

Kind regards

over 10 years ago

0 Elias Villegas M. over 10 years ago

TI__Guru* 76130 points

Hello,

Sorry for the delay.
Have you red the Flash Burner User's Guide?
Can you elaborate more on what you are trying to accomplish, I'm afraid you would require a firmware customization.
Regards

0 TI TUSB over 10 years ago in reply to Elias Villegas M.

Prodigy 20 points

Hello,

thanks for your reply.

I read the Flash Burner User's Guide but what im trying is to read the SW1 button state using the TUSB HID interface and Microsofts HID generic driver. I tried reading the reports and the interrupt endpoint-files the HID-driver provides - without any succeed.

Best regards

Interface

Interface forum

TUSB9261 / HID communication