TLK10232_AMUXA_Pin

user4366098

Other Parts Discussed in Thread: TLK10232

Hi,

If i want to use the tlk10232 in 10G KR mode , "AMUXA" and "AMUXB" must be left unconnected ? Can both of them be connected to gnd ?

Thanks !!

over 10 years ago

0 Luis Omar Moran over 10 years ago

TI__Genius 16150 points

Hi,

In device application, these signals should be left unconnected (floating).

Regards!
Luis

0 user4366098 over 10 years ago in reply to Luis Omar Moran

Prodigy 100 points

Hi,
In device application, can these signals be connected to gnd ? If these signals connect to gnd , will affect the tlk10232 chip work well ? I have two same board , one can wok well , another will loss packet , but no error data.
Regards!

0 Luis Omar Moran over 10 years ago in reply to user4366098

TI__Genius 16150 points

Hello,

The device should be work if you connect AMUXA & AMUXB to GND.

Regards!
Luis

Interface

Interface forum

TLK10232_AMUXA_Pin