HD3SS3415, spec pinout error and temp mismatch with distributor info

David Lacasse

Intellectual 450 points

pinout in page 1 and page 6 are different in the figure.

Digikey and mouser says -40to85 when pdf says 0-70.

thanks

over 10 years ago

0 Adam Torma over 10 years ago

TI__Mastermind 45575 points

David,

Thank you for bringing this to our attention. I am moving this thread to the Consumer and Computing Interface forum where I have seen this device supported.

Thank you,
Adam

0 Vladimir Vuksanovic over 9 years ago in reply to Adam Torma

Prodigy 40 points

I am looking to use this device, and I found these mismatches in the datasheet:
1. The datasheet info is conflicting re. temperature range. Pg.1 and 6 say 0-70c, pg.12 and 19 show -40C to +85C.
Also, ordering info on the webpage shows -40C to +85C. Which is correct?
2. Also, pinout diagrams on pg.1 and pg.4 are different - which one is correct??

0 Jose Carlos Gil over 9 years ago in reply to Vladimir Vuksanovic

TI__Genius 9315 points

Hi Vladimir,

I will check for the correct values and make it fixed.
Thank you so much for pointing out.

Regards.
JC

0 Jose Carlos Gil over 9 years ago in reply to Jose Carlos Gil

TI__Genius 9315 points

Just to inform that new fixed datasheet is uploaded on the web.

Regards.
JC