Device Recommendation...

Amanda Ross95

Other Parts Discussed in Thread: TUSB1310A

Good Morning,

I'm looking for some advice on a product, what would you suggest if we wanted to do parallel/localbus to USB3.0 device in order to go from I.MX6 to USB3.0 host x86 SBC?

Do we have anything that meets these parameters?

Thanks so much!

-Amanda

over 9 years ago

0 Diego Cortes over 9 years ago

TI__Mastermind 36085 points

Hello,

I am assuming that the IMX6 is a cortex processor, please verify that the device has PIPE & ULPI interfaces. If so, then the right option for you would be our USB PHY, the TUSB1310A.

Regards,
Diego.

0 Amanda Ross95 over 9 years ago in reply to Diego Cortes

TI__Intellectual 2740 points

In the case that the IMX6 we're using doesn't support USB3.0, how should we go about using this device?

0 Diego Cortes over 9 years ago in reply to Amanda Ross95

TI__Mastermind 36085 points

Amanda,

No you shouldn't, this device is just the USB PHY, and it needs the processor with USB3 link capabilities.

Regards,
Diego.

Interface

Interface forum

Device Recommendation...