Programming TPS65982 EVM with bin file

Manjunath S

Prodigy 80 points

Other Parts Discussed in Thread: TPS65982, TPS65982-EVM

How to program the bin file generated from config tool in to TPS 65982 EVM using launch pad TM4C123GXL?

over 9 years ago

0 Kevin Jones over 9 years ago

TI__Prodigy 495 points

Please refer to www.ti.com/.../tps65982-hiutility for examples on how to configure/program the TPS65982 via the host interface. Please also consider this application note. www.ti.com/.../getliterature.tsp

Support for TM4C123GXL is not natively provided, but the above documents should get you started.

If you just want to reprogram the EVM please consider the methods mentioned in section 9 of the EVM users guide. www.ti.com/.../getliterature.tsp

Regards,

Kevin

0 Srikant Varma over 9 years ago in reply to Kevin Jones

Prodigy 30 points

Hi Kevin,
Thanks for your reply.
We donot have a Aardvark but do have launch pad TM4C123GXL. Can we use to load the code to TPS65982_EVM from Config tool. KIndly help. Thanks.

0 Kevin Jones over 9 years ago in reply to Srikant Varma

TI__Prodigy 495 points

Srikant,

Aardvark is currently the only supported option. The documentation should allow you to extend this to other methods of programming a SPI flash. There is nothing unique about the SPI flash on the TPS65982-EVM so I'm sure others possibilities exist.

regards,

Kevin

Interface

Interface forum

Programming TPS65982 EVM with bin file