TIDA-00162 support

TI Lady

Other Parts Discussed in Thread: TIDA-00162

hI there,

Referring to TI’s TIDA-00162 Dev Platform that uses the OmniVision OV10635 image sensor plus TI’s DS90UB913A & DS90UB914A SerDes, can they kindly provide us a working set of configurations (for each of the three parts)?

thanks in advance,

over 9 years ago

0 TI Lady over 9 years ago

Genius 4025 points

Any response here?

0 Ed Walker over 9 years ago in reply to TI Lady

Prodigy 5 points

This TI design does not have any Hardware available anymore for us to provide the configurations.
With the next update cycle it is going to be removed from the TI design page.

0 Sean Thornton1 over 9 years ago in reply to Ed Walker

TI__Expert 5210 points

Hello,

Please order the TIDA-00162 reference design kit from the link below:

www.spectrumdigital.com/.../

Thank you,
Sean

0 ikon over 9 years ago in reply to Sean Thornton1

Genius 5355 points

Hi Support,

Is there any Xilinx FPGA based reference design to interface with this FMC card?

Thanks.

0 Dac Tran over 9 years ago in reply to ikon

TI__Expert 7395 points

Check logicbricks.com

Dac Tran

SVA APPS

0 Omin Chou over 9 years ago in reply to Dac Tran

Genius 3555 points

Hi all,
I checked TIDA-00162 schematic that included I2C accelerator and info EEPROM. May I know the purpose on these two components?
Please help to confirm if I remove them without software change.

B.R.
OC

0 Dac Tran over 9 years ago in reply to Omin Chou

TI__Expert 7395 points

The I2C accelerator is not required for I2C communication with DS90UB914A. The EEPROM are common for FMC adapters to identify the board.

Dac Tran

SVA APPS

0 Omin Chou over 9 years ago in reply to Dac Tran

Genius 3555 points

Hi Dac,

Thanks for your confirmation.

B.R.
OC

Interface

Interface forum

TIDA-00162 support