TUSB9261 / Procedure to program firmware to flash

S.Satoshi

Other Parts Discussed in Thread: TUSB9261

Hi,

Please let me ask about procedure to program firmware to flash. I'm asking this because my customer plan to program firmware to blank flash from uC on their test board.

Best Regards,

Sonoki / Japan Disty

over 9 years ago

0 Elias Villegas M. over 9 years ago

TI__Guru* 76130 points

Hello,
The Section 3 of the Flash Burner User's Guide describes how to "build" the firmware and send it to the attached EEPROM through the TUSB9261(www.ti.com/.../sllu125d.pdf ).
What I recommend is to use the Flash Burner to create a .bin or .hex of the compiled version of the firmware and then use any standard method to write this .bin/.hex files to the attached EEPROM.

Regards

0 S.Satoshi over 9 years ago in reply to Elias Villegas M.

Guru 21685 points

Hi Elias,

My customer know the firmware before program and after program by using Flash Burner are different. I think you recommned to use .bin or .hex file created by using Flash Burner and program to Flash memory. Is my understanding correct?

Best Regards,
Sonoki

0 Elias Villegas M. over 9 years ago in reply to S.Satoshi

TI__Guru* 76130 points

Correct, they have to use the .bin/.hex file created by the Flash burner.
Regards

0 S.Satoshi over 9 years ago in reply to Elias Villegas M.

Guru 21685 points

Hi Elias,

Thank you for your commetn. I'll request customer to try to use .bin/.hex file created by the Flash burner. Let me ask again when I'll receive further question.

Best Regards,
Sonoki

Interface

Interface forum

TUSB9261 / Procedure to program firmware to flash