DS90UB960 match with ds90ub913a-q1

Lucifer

Expert 2600 points

Other Parts Discussed in Thread: DS90UB913A-Q1

Dear Sir,

I am studying DS90UB960 and ds90ub913a-q1 specification now. and have some issue below need to be clarification.

1. DS90UB960 to ds90ub913a-q1 (RAW mode), can ds90ub913a-q1 be inputed by YUV422 8bits mode?

(2) is DS90UB960 MIPI visual channel line-interleaved bringing ?

Thanks.

over 9 years ago

0 Donald Jones over 9 years ago

TI__Mastermind 22610 points

DS90UB913A-Q1 25-MHz to 100-MHz 10/12-Bit FPD-Link III Serializer

Moving from the 'Linear Regulator Forum' to the 'High Speed Interface Forum'

0 Nao over 9 years ago in reply to Donald Jones

Genius 4905 points

Hi,

Does anyone know the answer of these questions?
I have same questions.

Regards,
Nao

0 Mark Sauerwald88474 over 9 years ago in reply to Nao

TI__Genius 13475 points

When pairing the DS90UB913A serializer with a quad deserializer, the recommended deserializer would be the DS90UB964.

You are able to configure the DS90UB964 to take inputs from 913A based cameras that are in YUV mode. The input to the 913 is either 10 or 12 bits, so the data format would be for either 10 or 12 bit YUV.

When there are multiple cameras connected to one DS90UB964, the CSI output packets are differentiated by the use of the MIPI virtual channels.

0 Nao over 9 years ago in reply to Mark Sauerwald88474

Genius 4905 points

Mark-san

Thank you for you feedback.
I have UB960 EVM, so I want to check that we can use UB913 with UB960.
Can I use this sets?

Regards,
Nao

Interface

Interface forum

DS90UB960 match with ds90ub913a-q1