• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 32 subscribers
  • Views 532 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS92LV2411: TEST Condition

Sho Ogane
Genius 5575 points
Part Number: DS92LV2411

Hi all

I would like to the get information of Figure.1 Test condition in datasheet.

-The value of Ca and Cb
-Drive current

Is 50 ohm dumping resister?

If you have ditail serializer circuit, please tell tell me it,
and  could you please give me the clock measurement waveform at 5MHz or 9MHz or 10MHz if you have. 

Sorry, I would like to get your answer as soonas possible,

Best Regards,
Sho

  • 0
    Genius 5575 points

    Hi all,

    Sorry, I would like to know the INPUT Test circuit,
    CLKIN Input Transition Time is recommended 0.5ns to 2.4ns.
    It is difficult for my cutomer to meet the above standards.
    Please tell me the jig or tool for entering the input clock.
    Please give me the the wave if possible

    Best Regards,
    Sho

  • 0 in reply to Sho Ogane
    Genius 5575 points

    Hi all,

    How about my question?

    My customer use SoC and pallarel signal and clock input to DS92LV2411.
    I would like to know the test circuit of pallarel input.

    I think you use FPGA for the test of parallel input.
    If possible, I would like to know the following information,
    the value of dumping resister and drive current etc...

    Best Regards,
    Sho