• State
  • Locked Locked
  • Replies 1 reply
  • Subscribers 33 subscribers
  • Views 362 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS90CR288A: Query over LVDS to RGB data transmission

Pavithra Sathiyanarayanan
Prodigy 40 points
Part Number: DS90CR288A

From the Datasheet of DS90CR288A its understood that the strobe Signal helps to output the parallel data at the same time.

In that case for LVDS to RGB display interface whether the VSYNC, HSYNC and DE can be connected to the Parallel dataline itself?

  • 0
    TI__Mastermind 29655 points
    Hi Pavithra,

    There may be some confusion about what a "strobe" is. The DS90CR288A always strobes on the clock's rising edge, which means that the parallel outputs for the DS90CR288A are meant to be sampled at the time of the output clock's rising edge.

    The RGB outputs and the VSYNC, HSYNC, and DE are meant to be connected to the parallel outputs, with the most common mapping shown in the following app note in Table 1: www.ti.com/.../snla014.pdf

    Regards,

    Michael