TUSB7320: May we have TUSB7320 driver to support "Linux kernel 3.18.31(above version)"?

Chen Bogey8

Part Number: TUSB7320

Hi Sir

1.May we have TUSB7320 driver to support "Linux kernel 3.18.31(above version)"?

2.My customer application as below, may we check with you if my customer need add redriver in downstream port or TUSB7320 output capacity can cover loss? or may you have suggestion can advise us?

Bogey

over 8 years ago

0 Elias Villegas M. over 8 years ago

TI__Guru* 76130 points

Hello,
The linux drive is managed by the linux community, you will have to go with them for driver support.
Depending on your layout, you may need to add a re-driver indeed, my recommendation is to leave the PCB footprint ready in case you need the re-driver. You can find a solution at below link, I will also forward this to the re-driver expert for a recommendation.
Regards
www.ti.com/.../usb-repeater-products.page

0 Diego Cortes over 8 years ago in reply to Elias Villegas M.

TI__Mastermind 36085 points

Hello

The TUSB7320 should be fully functional under the mentioned kernel (actually, the support for xHCI started in the kernel 2.6 and became stable with the version 3).

Regards,
Diego.

0 Chen Bogey8 over 8 years ago in reply to Diego Cortes

Mastermind 9990 points

Hi Diego
Sorry for i have a little confuse, so it is mean we can direct use TUSB7320 in Linux kernel 3.18.31 version without driver?
Bogey

0 Roberto Diaz over 8 years ago in reply to Chen Bogey8

TI__Genius 11255 points

Hello Bogey,

The TUSB7320 will use the native driver included by default on kernel, it means you'll not need any additional driver.

Regard,
Roberto

Interface

Interface forum

TUSB7320: May we have TUSB7320 driver to support "Linux kernel 3.18.31(above version)"?