TUSB9261-Q1: TUSB9261-Q1 Interface Question

Chun Youngsu

Expert 2485 points

Part Number: TUSB9261-Q1
Other Parts Discussed in Thread: TUSB9261

Hi.

I have a question about TUSB9261-Q1.

Can I connect the image sensor's parallel data to the tusb9261-q1?

The data you want to use is shown below.

PCLK, VSYNC, HSYNC, DATA 8 lines.

Can I get a quick answer?

Thanks.

over 8 years ago

0 Roberto Diaz over 8 years ago

TI__Genius 11255 points

Hello,

Could you please detail a little more how are you planning your design? a block diagram will be useful to understand your setup.

Please note the default firmware configure the TUSB9261 to be used as a mass storage device.

0 Chun Youngsu over 8 years ago in reply to Roberto Diaz

Expert 2485 points

Hi.

Attach the block diagram you want to configure.

The existing chip was Cypress's USB 2.0 Peripheral Controller (CY7C68013A-56LTXI)

0 JMMN over 8 years ago in reply to Chun Youngsu

TI__Guru 60870 points

Hi Chun,

The TUSB9261 is not intended as a general purpose USB 3.0 controller, it is a USB 3.0 to SATA controller. The application shown in the block diagram above is not a good fit for the TUSB9261.

Regards,
JMMN

Interface

Interface forum

TUSB9261-Q1: TUSB9261-Q1 Interface Question