DS250DF410: DS250DF410 pin out and Orcad schematic symbol

Eugene Fleisher95

Part Number: DS250DF410

Hello,

I am looking for the complete data sheet ( with pin outs) and seems can not find it on the TI web
Can you please advise how to get it ASAP as well as Orcad schematic symbol and SI models?
Thank you for the help.

Eugene

over 9 years ago

0 Rodrigo Natal over 9 years ago

TI__Mastermind 19235 points

Hi,

You can request and gain access to the DS250DF410 datasheet and other collateral such as EVM board design files via the TI product page. Click on the link below "Special Note."

www.ti.com/.../DS250DF410

For the DS250DF410 we generated an Altium symbol, which was used for the EVM schematic.

0 Eugene Fleisher95 over 9 years ago in reply to Rodrigo Natal

Prodigy 40 points

So can I get Altium one?

It can be converted then to Orcad,

Could you point me where I can download it.

Thanks,
Eugene

0 Rodrigo Natal over 9 years ago in reply to Eugene Fleisher95

TI__Mastermind 19235 points

If you provide your email address I can follow up via direct message.

Rodrigo Natal

HSSC Applications Engineer

0 Eugene Fleisher95 over 9 years ago in reply to Rodrigo Natal

Prodigy 40 points

Sure, please use bingoeugene@gmail.com
Thank you for the help.
Eugene

0 Rodrigo Natal over 9 years ago in reply to Eugene Fleisher95

TI__Mastermind 19235 points

Great, I've emailed you the file.

0 Eugene Fleisher95 over 9 years ago in reply to Rodrigo Natal

Prodigy 40 points

Hi Rodrigo,

Need a little bit more of your help.

As I understand there is tool to be used in order to do tuning and programming for the retimer.

I have downloaded programming guide and some info on EPPROM format and some "updater" application but seems somethign is still missing.

Can you check please if you can send me the following:

- GUI tool application that can be installed and work together with updater

- Default EEPROM file ( or couple of versions of the file ) to start and see if it can work in our application

- any BMC utility ( we are using Aspeed 2400) to do interactive I2C tuning.

Would greatly appreciate all the help .

Thanks,
Eugene

0 Rodrigo Natal over 9 years ago in reply to Eugene Fleisher95

TI__Mastermind 19235 points

Hi Eugene. Just confirming that I've responded to this item already via direct email.

Cordially,

Rodrigo Natal

HSSC Applicaitons Engineer

Interface

Interface forum

DS250DF410: DS250DF410 pin out and Orcad schematic symbol