TMDS171: SPDIF IN pull down resistor

NAOKI AOYAMA

Guru 11215 points

Part Number: TMDS171

Hello,

Our customer use the TMDS171.

The customer do not use ARC system.

It is mentioned connecting a 500kohm resistor to GND at SPDIF IN on the datasheet.

Is it possible to use a 470kohm or 510kohm resistor?

Best Regards,

Naoki Aoyama

over 7 years ago

0 Francisco Javier Zamudio over 7 years ago

TI__Expert 5455 points

Hello Naoki

We recommend using 500k because with this value the power supplies current is reduced more than 20 mA. If you have a different value, this current level will change. I recommend you to use 500k.

Regards
Francisco

0 NAOKI AOYAMA over 7 years ago in reply to Francisco Javier Zamudio

Guru 11215 points

Hello Francisco,

Thank you for your reply.
If the customer don't care about current consumption,
is it possible to use any value for pull down resistor?
A 500kohm resistor is not available at E12 or E24 series.

Regards,
Naoki Aoyama

0 Francisco Javier Zamudio over 7 years ago in reply to NAOKI AOYAMA

TI__Expert 5455 points

Hello Naoki

If that is the case, you can use a close resistor value.

Regards
Francisco

0 NAOKI AOYAMA over 7 years ago in reply to Francisco Javier Zamudio

Guru 11215 points

Hello Francisco,

Thank you for your reply.
I will feedback the customer this information.

Thanks,
Naoki Aoyama

Interface

Interface forum

TMDS171: SPDIF IN pull down resistor