This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello Team,
do you see any problem if between the FPGA and the SN65LVDS4 only one 100ohm resistor is used?
In particular the 100ohm resistor is closer to the SN65LVDS4 rather than the FPGA.
I would say that the trade off might be related to the trace length and if the SN65LVDS4 is really close to the FPGA it might be good.
...or am I wrong and one resistor is a no go?
Thanks,
SunSet
Thanks Yaser,
yes the FPGA has LVDS output. I was thinking that two terminations would have been needed.
But fine with one...this the only on the board.
Thanks,
SunSet