Dear, Sir.
I2C communication over FPD-Link3 is described on SNLA131A, Application Report.
The multi-master is general on standard I2C. But I can't find clear explantion about that
through it.
I am guessing ;
The multi-master would not be realized over DS90UB925Q-Q1 & 926Q-Q1 because the
Arbitration is not supported.
I wonder my assumption is correct? Please give your advice for my double-confirmation.
Best Regards,
H. Sakai
Dear, Sir.
Thank you so much for your advice.
My questions have been getting clear due to training material.
Sorry again, but I would like to make sure about "Remote I2C_external slave access".
1) If added to SlaveID resister=SB on SER, attached I2C slave address=SB.
The read/write message would propagate to both 12C Slave #1 & #2?
2) If want to propagate the message to just only I2C Slave #2, to be eliminateed
SlaveID resister=SA on SER
Best Regards,
H. Sakai
