DS90UB913Q-Q1: DS90UB913 connection

John Lin41

1.The parallel out of my camera, it is only 8bit output. How the data pin connected to the DS90UB913?
Should it be connected to DIN[11:4] or DIN[7:0]?

2.When the camera data is only 8bit output, how to set Register 0x05 in DS90UB913?

over 7 years ago

0 Steven(Shenzhen) Shi over 7 years ago

TI__Mastermind 30515 points

what is the paired part with 913?

if it is ub934, you Need set 10bits mode and can use Any d0-d9. the input of ub913 is mapped with ub934's output pins. iF it is ub96x, you should set 10bits mode and select either d0-d7 or d2-d9 (high 8bits).

for mode setting, it is set through ub934 or ub964. you can refer their datasheet.

Steven

0 Kenichiro over 7 years ago in reply to Steven(Shenzhen) Shi

Mastermind 9165 points

Hi,

This would help you.

DS90UB914 Parallel Interface
e2e.ti.com/.../1337963

Thanks,
Ken

Interface

Interface forum

DS90UB913Q-Q1: DS90UB913 connection