TUSB3410: TUSB3410: Using the TUSB3410 as a USB to I2C bridge

Dominik Wegertseder

Prodigy 25 points

Part Number: TUSB3410

Hello TI,

I would like to use the TUSB3410 as I2C to Uart Bridge - where can I get the firmware for the device?

Best Regards

Dominik

over 7 years ago

0 Michael.Walker over 7 years ago

TI__Mastermind 19720 points

The firmware is under the Tools and Software section of the product page.

0 Dominik Wegertseder over 7 years ago in reply to Michael.Walker

Prodigy 25 points

Dear TI,
thank you for the answer. Unfortunately I am blind or it is too hot in the office, but I could not find very much on I2C application on the site (most is serial only).
I was able to find the TUSB3x10_I2C_API.dll dll, with very limited documentation, but I think I need a firmware for the EEPROM or the apploader to get it working. I would appreciate if you could send me the EEPROM image. If there is more documentation on I2C mode I would also be interested in.

Best Regards
Dominik

0 Brian Quach over 7 years ago in reply to Dominik Wegertseder

TI__Expert 4325 points

Hi Dominik,

You are correct, the I2C FW is not posted online currently. Let me work on getting it for you.

Regards,

Brian

Interface

Interface forum

TUSB3410: TUSB3410: Using the TUSB3410 as a USB to I2C bridge