DS90UB953-Q1: How to access UB953 attached to on DS90UB954 by SER_ID and SER_ALIAS_ID?

David,
have you used UB964? if yes, they have same channel control skill. diff. channels are managed respectively.
pls refer to 954's d/s page65 on its reg. maps.

regards,
Steven

Dear Steven,

I haven't any experience on UB964 or UB954, in fact , I had put a request on how to initialize 954/953 step by step months ago, but it seems TI cannot provide these application guidance.

There are so many registers in both of 953/954, how to initialize them step by step is necessary for the new comer.

Best

David,
I know your concern, please use below tool to understand the setting:
1. reading UB96x EVM user guide page22, one example on how to set the UB964.
2. similar case in e2e.
3. to use UB96x, firstly you should know the video format, CSI2 port, forwarding mode, etc., based on the strap setting of UB96x, and you can set the relative reg. in d/s.

regards,
Steven

FYI UB96XEVM user guide in www.ti.com.
www.ti.com/.../DS90UB964-Q1EVM


regards,
Steven