This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TUSB1211: ULPI trace length / delay spec?

Part Number: TUSB1211

Hi team,

The TUSB121X USB2.0 Board Guidelines document, Section 3.02, says that ULPI interfaces should have equal path lengths to have equal delays. I'm curious to know, is there a spec to how much delay variation the interface can tolerate?

Thanks,

Brian Angiel

  • Brian

    All the ULPI interface signals are synchronous to the clock, so everything is based off the clock. Please refer to ULPI spec, Figure 7 for the ULPI timing diagram, and then you can reference to the setup/hold time requirement in the TUSB1211 datasheet as a guide when doing the routing to make sure setup/hold time does not get violated.

    Thanks
    David