single ended to two differential LVDS outputs

PRAHLAD Supeda

Expert 6160 points

Other Parts Discussed in Thread: SN65LVDS34, DS90LV011A

My customer have following requirements -

Have a requirement of ultra low jitter, clock(1Ghz) buffer with -

1. One single ended NIM(fast-negative logic) input to two differential LVDS &

2. One single ended 3.3V LVTTL input to two differential LVDS device.

Could you please help recommend suitable part?

over 6 years ago

0 Yaser Ibrahim over 6 years ago

TI__Genius 10250 points

Hello Supeda,

I don't think we have something that will take NIM signal directly. I will look more into it and get back to you. Do you know the specific jitter requirement?

0 Prasanta Halder over 6 years ago in reply to Yaser Ibrahim

Prodigy 20 points

Hi Yaser,

The jitter requirement is less than 20ps. I think Negative ECL with configurable offset will support NIM signal. Do you have any device for NECL input?

Regards,
Prasanta

0 Prasanta Halder over 6 years ago in reply to Yaser Ibrahim

Prodigy 20 points

Hi Yaser,

The jitter requirement is 20ps. I think device with Negative ECL input with configurable offset will support NIM. Do you have any device supporting NECL logic input.

Regards,
Prasanta

0 Yaser Ibrahim over 6 years ago in reply to Prasanta Halder

TI__Genius 10250 points

Hi Prasanta,

Please check out SN65LVDS34 which has a wide input common mode from -4 to 5V: www.ti.com/.../sn65lvds34 .
Also check out this app note that discusses how to use it to receive NECL input: www.ti.com/.../slla101 .

For single ended LVTTL to LVDS, please check out DS90LV011A.

Regards
Yaser

Interface

Interface forum

single ended to two differential LVDS outputs