TUSb1310 IBIS model.

Shahbaz Assad

Prodigy 30 points

Other Parts Discussed in Thread: TUSB1310, TUSB9260

Hi All,

Can any body provide me to the TUSb1310 (USb3.0 PHY) ibis model.

I need to run the SI simulation using IBIS model.

If not, kindly provide me the spice model for the device.

Regards

Shahbaz Assad

Design Engineer

Whizz Systems, Inc

over 15 years ago

0 Wes Ray over 15 years ago

TI__Intellectual 2995 points

The IBIS model is attached.

TUSB1310.ibs

0 Shahbaz Assad over 15 years ago in reply to Wes Ray

Prodigy 30 points

Can some body tell me what is the reference of SSTX/RX signals.

Analogue ground or digital ground??

Should i connect the USB connector ground pins to Analogue ground or digital ground?

regards

0 Wes Ray over 15 years ago in reply to Shahbaz Assad

TI__Intellectual 2995 points

The SS signals should be referenced to anaolg ground.

Have a look at the TUSB9260 implementation guide for an example of how to connect the USB connector grounding.

http://focus.ti.com/lit/an/slla301b/slla301b.pdf

0 Shahbaz Assad over 15 years ago in reply to Wes Ray

Prodigy 30 points

Hi Experts,

Is there any evaluation board of TUSB1310?

Can any body give me the TUSB1310 reference schematics?

Regards

Shahbaz Assad

0 DHarmon over 15 years ago in reply to Shahbaz Assad

TI__Genius 16870 points

Since the TUSB1310 PHY must be used with an FPGA to perform any functions, we rely on 3rd party FPGA development kits for reference designs.

PLDA, Evatronix, and System Level Solutions have available development platforms. See the TUSB1310 Product Folder for more information on the PLDA offerings. In addition, Synopsys has a development platform called the HAPS that they will have a daughter card with the TUSB1310 on to enable USB 3.0 functionality.

We have an implementation guide available in the product folder that discusses board layout and power issues, but much of the critical design activity is really the FPGA that is used.

Interface

Interface forum

TUSb1310 IBIS model.