TUSB1310A: about PIPE interface for TUSB1310A

Vera Mao

Expert 5065 points

Part Number: TUSB1310A

Hi dear supporting team,

for TUSB1310A:

1. could PIPE interface has lower than 250M speed? (d/s only mentioned 16bit 250M)

2. what;s the max load ability for PIPE? (such as at pF@250M)

tks~!

over 6 years ago

0 JMMN over 6 years ago

TI__Guru 60870 points

Hi Vera,

1. No, the PIPE interface only support 250 MHz operation.
2. Maximum load is 10 pF.

Regards,
JMMN

0 penghu liu over 6 years ago in reply to JMMN

Prodigy 10 points

Part Number: TUSB1310A

Hi dear supporting team,

for TUSB1310A:
1、Are TX_DATA and TX_DATAK synchronous for TX_CLK?
2、Are RX_DATA,RX_DATAK and RX_VALID synchronous for PCLK?
3、Are CONTROL , STATUS and CONFIGURATION SIGNALS synchronous for TX_CLK or PCLK?
4、How much is skew between PCK AND TX_CLK?

0 JMMN over 6 years ago in reply to penghu liu

TI__Guru 60870 points

Please see section 4.7.2 and 4.7.3 in the datasheet for information on PIPE timing.

Please be aware that the TUSB1310A is not recommended for new designs and only limited support is available.

Regards,
JMMN

Interface

Interface forum

TUSB1310A: about PIPE interface for TUSB1310A