HD3SS3202: Maximum current rating of mux switches.

Mark Dahlman

Intellectual 2005 points

Part Number: HD3SS3202

I have an application where there is a potential for the high speed signal lines to be shorted to ground. I need to know the maximum current rating of the high speed signal switches to make sure they don't get damaged during this short condition.

Thanks for your help,

Mark Dahlman

over 5 years ago

0 Brian Zhou over 5 years ago

TI__Guru** 119670 points

the switch is on or off for the pin grounded.

0 Mark Dahlman over 5 years ago in reply to Brian Zhou

TI__Intellectual 2005 points

The switch is on and current is flowing from the transceiver through the mux to ground.

0 Brian Zhou over 5 years ago in reply to Mark Dahlman

TI__Guru** 119670 points

on resistance is 5ohm, current is depend on DC voltage on the channel. normally there is AC cap on the channel, so current should be very low.

0 Mark Dahlman over 5 years ago in reply to Brian Zhou

TI__Intellectual 2005 points

In this application the channel is DC coupled. The voltage on the channel could be as high as 2V. I need to know the current rating of the switch so I know how much resistance is needed in the channel to limit the current.

0 Brian Zhou over 5 years ago in reply to Mark Dahlman

TI__Guru** 119670 points

there is no current limit for the channel on, not sure if the source can handle the current 2v/5ohm=400ma.

0 Brian Zhou over 5 years ago in reply to Brian Zhou

TI__Guru** 119670 points

as long as input voltage meet spec, it should be fine.

Interface

Interface forum

HD3SS3202: Maximum current rating of mux switches.