TCAN4550EVM: About Communication status evaluation

Tsukui Yusuke

Guru 21930 points

Part Number: TCAN4550EVM
Other Parts Discussed in Thread: TCAN4550

Hi,

Please tell me how to evaluate TCAN4550EVM.
Customers want to consider CAN FD introduction using TCAN4550EVM.
http://www.ti.com/tool/TCAN4550EVM

However, this EVM does not have a controller such as MUC.
Therefore, the customer can not be evaluated only in the EVM purchase.
Could you tell me the evaluation set TI recommends to try the protocol test etc.

Best Regards,
Yusuke

over 6 years ago

0 Eric Hackett over 6 years ago

TI__Guru 74172 points

Yusuke-san,

Typically our customers have connected their own MCU boards to our EVM for evaluation, using our starter software code and software guide as a starting point. We will also have a TCAN4550 boosterpack that connects to a TI launch pad released next month that you can look for.

If you email me directly, I can send over the starter code and software user's guide.

Regards,

0 Tsukui Yusuke over 6 years ago in reply to Eric Hackett

Guru 21930 points

Eric-san,

Thank you for your support.
I understand the TCAN4550 evaluation environment.

I want starter code and software user's guide.
Could you tell me your email address?

Best Regards,
Yusuke

0 Eric Hackett over 6 years ago in reply to Tsukui Yusuke

TI__Guru 74172 points

Yusuke-san,

If you click my username, it will take you to a page where you can find my email.

Regards,

Interface

Interface forum

TCAN4550EVM: About Communication status evaluation