• State TI Thinks Resolved
  • Locked Locked
  • Replies 1 reply
  • Answers 1 answer
  • Subscribers 34 subscribers
  • Views 683 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TUSB320: Changing mode configuration(DFP/UFP/DRP) during power-on & cable connected

Noriyuki Takahashi
Genius 12210 points

Part Number: TUSB320

Hi team

Are there anyways to change the mode configuration during power-on & Type-C cable connected?

I am wondering the mode configuration can be changed dynamically. e.g. changing voltage state of PORT-pin.

Regards,

Noriyuki Takahashi 

  • 0
    TI__Guru**** 192301 points

    Takahashi-san

    The TUSB320 device can be configured as a downstream facing port (DFP), upstream facing port (UFP), or dualrole port (DRP) using the tri-level PORT pin. The PORT pin should be pulled high to VDD using a pullup resistance, low to GND or left as floated on the PCB to achieve the desired mode. The TUSB320 device samples the PORT pin after reset and maintains the desired mode until the TUSB320 device is reset again.

    But why not leave TUSB320 configured as DRP and let it switching between UFP and DFP?

    Thanks

    David