• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 33 subscribers
  • Views 287 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DS100KR401: When we use Sigcon Architect the EEPROM page will not reflect low level page change , so we can not generate EEPROM data

Josh Huang1
Prodigy 30 points
Part Number: DS100KR401

we are trying to generate the EEPROM data for our DS100KR401 repeater but we found the low level page change will not reflect to the EEPROM page , so we can not generate EEPROM data , we try to save config and load config again but result seems all the same

  • 0
    TI__Mastermind 43795 points

    Hi Josh,

    To make register updates from the "Low Level Page" appear in the "EEPROM Page" you should only have to click on the "Update Slot from Device" button.  It is also possible to make changes on the EEPROM side and push them back to the register page by clicking the "Update Device from Slot" button.

    Regards,

    Lee