DS250DF410EVM: Screw holes close to the Chip

Shalom Shalom

Part Number: DS250DF410EVM
Other Parts Discussed in Thread: DS250DF410

Hello

there is 4 holes around the Chip, i was assume that the holes are for Heat-Sink but i couldn't find any suitable Heat-Sink.

is this the application of those holes?

if i want to connect Heat-Sink to the board, do you have some product for that?

Thank you

Shalom

over 6 years ago

0 Brian Zhou over 6 years ago

TI__Guru*** 149690 points

should be for socket

0 Shalom Shalom over 6 years ago in reply to Brian Zhou

Prodigy 30 points

Socket above the chip? for what?

0 Brian Zhou over 6 years ago in reply to Shalom Shalom

TI__Guru*** 149690 points

it's either for socket or solder down chip

0 Lee Sledjeski over 6 years ago in reply to Brian Zhou

TI__Mastermind 43795 points

The PCB was designed to accomodate a bolt down socket or a solder down device. The evaluation module board uses a solder down method of attachment for the DS250DF410 device.

Regards,

Lee

0 Shalom Shalom over 6 years ago in reply to Lee Sledjeski

Prodigy 30 points

Thank you

Interface

Interface forum

DS250DF410EVM: Screw holes close to the Chip