DS90UH948-Q1: White balance control register

Hello Shinji,

The registers in the DS90UH948 are loaded from default, any changes from the default must be loaded each PDB or register 1 reset. 

Section 7.5.1, 7.5.2. 7.5.3 of the datasheet must be followed for the LUT loading procedure, and mapping when 888, 24bit; 666 18bit; color are used.

The sequence order for the LUT programming, is listed in section 7.5.3 of the datasheet.  Figure 42 has the mapping for 24bit, 18bit, and 16 bit color.

Also see reg 0x2A (White balance control register)

Hi,

I could not find the page register description in DS90UH948 datasheet. 

Could you advise where is the LUT register and how to access to that register? 

regards,