DS90UB948-Q1: I2C interface

Kevin Xiong

Part Number: DS90UB948-Q1
Other Parts Discussed in Thread: DS90UB947-Q1,

Hi,

The serializer is DS90UB947-Q1 and the deserializer is DS90UB948-Q1. I want to control 948 using 947's I2C. The I2C signal transmits through LVDS signal and the I2C signal can output through 948's I2C interface.

Can I get the function? If so, could you please tell me how to configure 948 and 947?

Thanks.

Kevin Xiong

over 5 years ago

0 Steven(Shenzhen) Shi over 5 years ago

TI__Mastermind 30515 points

Yes, this can do. Kevin.

As one of key features is I2C over FPD-Link communication, pls see below app. note i2c over FPD-Link? here you can get how the I2C is communicated over FPD-Link and how to set the reg. (pass-through and alias slave ID / slave ID) ,.thanks.

www.ti.com/.../snla131a.pdf

regards,

Steven

0 Kevin Xiong over 5 years ago in reply to Steven(Shenzhen) Shi

Expert 2340 points

Hi Steven,

From the application note, I can NOT find how to configure the register? or which register? Could you please help me to clear the point?

Thanks.

Kevin Xiong

0 Steven(Shenzhen) Shi over 5 years ago in reply to Kevin Xiong

TI__Mastermind 30515 points

kevin,

if you need visit UB948 reg., this is call remote I2C, pls:

1. get the register "i2c pass-through" in d/s, and set this bit as "enable"

2. set the de-ser alias ID reg. in ub947 d/s, and assign one IDX for this.

then, you can visit UB948's register with the IDX set in the reg. "de-ser alias ID" of UB947.

best regards,Steven

Interface

Interface forum

DS90UB948-Q1: I2C interface