TPS65987D: Dynamically switch power for DP1.2 to DP1.3

Michael Balourdas

Part Number: TPS65987D

Hello,

My customer is thinking about the need to dynamically switch from DP 1.2 to DP 1.3 in their system with TPS65987D. Is this possible? Is there any commands that need to come from their MCU to make this happen?

Thanks,

Michael

over 6 years ago

0 Atiq Rahman over 6 years ago

TI__Expert 5110 points

Michael,

Which DP pin assignment is the customer using?

0 Michael Balourdas over 6 years ago in reply to Atiq Rahman

TI__Expert 5705 points

Assignment C

0 Hari Patel1 over 6 years ago in reply to Michael Balourdas

TI__Genius 12700 points

Hi Michael,

Yes this should be possible with their MCU. Assignment C is correct for using DP 1.3. The customer will also need to ensure that the DP v1.3 signalling bit is set and when it needs to switch from 1.2 to 1.3, the "Multi-function Preferred" bit should be set to 0 and a HRST command should be sent by the UFP_D for a hard reset to re-enter DP alternate mode into DP 1.3. This process is also described in detail in the DisplayPort Application Note, Section 5.2 here.

Thank you,

Hari

0 Michael Balourdas over 6 years ago in reply to Hari Patel1

TI__Expert 5705 points

Hi Hari,

Are you referring to this bit?

0 Hari Patel1 over 6 years ago in reply to Michael Balourdas

TI__Genius 12700 points

Hi Michael,

Yes, that is the bit I am referring to for the DP 1.3 support.

Thank you,

Hari

Interface

Interface forum

TPS65987D: Dynamically switch power for DP1.2 to DP1.3