DS90UB954-Q1: Connection to 933 serializer

Tomoaki Yoshida91

Genius 5255 points

Part Number: DS90UB954-Q1

Hi team,

We are using 954 with 933.

However, the CSI output of 954 is in the LP-11 state.

Probably the register setting is incorrect, but can you check it?

I want to communicate directly by e-mail.

Best regards,

Tomoaki Yoshida

over 6 years ago

0 Casey McCrea over 6 years ago

TI__Guru** 103215 points

Hello Tomoaki,

Please provide your programming steps and we can review them. Also please confirm that the 954 is pin strapped for the desired RAW MODE to match the 933 sensor configuration.

Thanks,

Casey

0 Tomoaki Yoshida91 over 6 years ago in reply to Casey McCrea

Genius 5255 points

Hi Casey-san,

Thank you for your support.

I will send you an email immediately.

Please wait.

Best regards,

Tomoaki Yoshida

0 Casey McCrea over 6 years ago in reply to Tomoaki Yoshida91

TI__Guru** 103215 points

Hello Tomoaki,

It is better if you can post the information here so that the issue resolution can be reused by others unless there is something specifically confidential which can not be shared here.

Thanks,

Casey

0 Casey McCrea over 6 years ago in reply to Casey McCrea

TI__Guru** 103215 points

Following up from email discussion - this issue was determined to be related to the sensor programming.

Interface

Interface forum

DS90UB954-Q1: Connection to 933 serializer