TUSB217-Q1: Pin 4 in I2C mode

Franz Figueroa32

Part Number: TUSB217-Q1

Hi E2E,

Good day!

Is it OK to leave pin4 (RX_SEN/ENA_HS) of TUSB217-Q1 floating if it is set to I2C mode?

Thank you and best regards,

Franz

0 Malik Barton57 over 6 years ago

Hi Franz,

This is OK, I do recommend leaving placeholder for resistors in case GPIO would like to be used later.

0 Franz Figueroa32 over 6 years ago in reply to Malik Barton57

Hi Malik,

Thank you for the confirmation.

Best regards,

Franz

Interface forum