TS3DV621: AUX and Dx input

K.Hamamoto

Guru 12155 points

Part Number: TS3DV621

Can we use AUX + / - pin as data input ? Also can we use D1 +/- pin as a clock input? (clock speed is 1GHz)

(The customer would like to swap between clock input of AUX pin and data input of D1 pin.)

Because as the PCB layout routing the above input pattern is easier to layout.

Best Regards,

Koji Hamamoto

0 Brian Zhou over 4 years ago

no,AUX channel is for low speed signal, less then 10Mhz.

regards,

brian

0 Brian Zhou over 4 years ago in reply to Brian Zhou

sorry for confusion, AUX pin is ptrtty same as data pin.

0 K.Hamamoto over 4 years ago in reply to Brian Zhou

Guru 12155 points

Hi Brian,

Thank you for your reply.

So, we can swap the both pins,right? (We need to care about the polarity.)

Best Regards,

Koji Hamamoto

0 Brian Zhou over 4 years ago in reply to K.Hamamoto

you need to swap at both input and output.

0 K.Hamamoto over 4 years ago in reply to Brian Zhou

Guru 12155 points

Hi Brian,

Thank you. I understood it's possible. (we need to swap at both of input and output.)

Best Regards,

Koji Hamamoto

Interface forum