• State Resolved
  • Locked Locked
  • Replies 1 reply
  • Subscribers 33 subscribers
  • Views 340 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

ALP: S-Parameter analysis in ALP v7 update

Takahiro Saito
Expert 5455 points
Part Number: ALP

Hi team,

When I update ALP with ALP update v7, I found there is an update in ALP that is S-parameter analysis tab.

Is there any document that explains what it is? Or, could you explain it simply? My customer is using DS90UB953/954.

Does this feature enable customer to measure S-parameter without any specific measurement equipment like VNA? 

Regards,

Saito

  • 0
    TI__Mastermind 21685 points

    Saito-san,

    >>>Is there any document that explains what it is? Or, could you explain it simply?

    Please check under the following install folder

    C:\Program Files (x86)\Texas Instruments\Analog LaunchPAD v1.57.0010\ALP_Documents

    You should find a document on using ALP_SPARAM_Support.

    >>>Does this feature enable customer to measure S-parameter without any specific measurement equipment like VNA?

    No. This feature allows customer to verify the measured S-parameter for channel/cable/PCB are within limits recommended for our device.

    Thanks,

    Vishy