TPS65988EVM: SPI Flash to Device Verification failed

Hello,

I've assigned this issue to the relevant expert who will get back to you shortly

Hi,

Tell me what you see when going through the steps below:

• Create a new project or load your project file into the GUI
• Connect EVM to your computer & power up the EVM
• Go to "adapter" menu and select configure I2C/SPI adapter setting
• Make sure FTDI is selected in the USB adapter menu.
• Hit the "Sweep I2C address ...." and click the start button. What do you see in the address sweep?
• If the address has some value like 0x20 and 0x24 then hit the "X" or close it and proceed to the next step
• Hit the "Test I2C HI Read (Mode...)" and tell me what do you see?
• Hit the "Test SPI Flash Read, what do you see in the returned field?

Once I see the above we can then decide what to do next.

Do you by any chance has an Aardvark I2C/SPI from Total Phase https://www.totalphase.com/products/aardvark-i2cspi/?

Regards,

Peter

www.totalphase.com/aardvark

Hi,

I have already dumped the binary file into the Flash multiple times using the same setup before. But the issue occurs randomly.

I have uninstalled and reinstalled the TI tool. Still I am getting anamolies