TPD8S300A: Asking for the TPD8S300 design suggestion

SHH

Mastermind 31116 points

Part Number: TPD8S300A
Other Parts Discussed in Thread: TPD8S300, STRIKE,

Hi Sir,

My customer would like design TPD8S300.

Would you please review schematic and layout and provide your comment?

BR,

SHH

over 4 years ago

0 Emma Hoying over 4 years ago

TI__Genius 9630 points

Hello,

You do not need to pull down the SBU1/2 pins.

RPD_G1/2 should be connected to C_CC1/2 if you need dead battery resistors, as shown below:

Also, if you need the USB Type-C port to stay connected during an IEC 61000-4-2 ESD strike, you should consider replacing the TPD8S300 with the TPD8S300A, which is pin to pin compatible.

Regards,

Emma

0 SHH over 4 years ago in reply to Emma Hoying

TI__Mastermind 31116 points

Hi Emma,

thanks for feedback. would you please review the attached schematic and layout here again?

txn.box.com/.../jyvkca4k4hftsxtzup7zj6y3w4vas48y

BR,

SHH

0 Emma Hoying over 4 years ago in reply to SHH

TI__Genius 9630 points

Hello,

I do not have access to box. Please provide the schematic and layout a different way.

Regards,

Emma

Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.

Interface

Interface forum

TPD8S300A: Asking for the TPD8S300 design suggestion