TPS65987D: Example code for "Flash from Binary"

Chanwook An

Part Number: TPS65987D
Other Parts Discussed in Thread: TPS65982

Hello,
I'd like to develop below program which is a part function of your "TPS65982 Configuration Tool".
Program for "Flash from Binary" function only.

Your configuration program is all mighty and omnipotent.
But, I don't want to change my configuration by anyone(Ex. manufacturer/operator/end-user of the system) who use your configuration program for initial configuration setting.
So, I want to provide only my configured binary to someone(Ex. manufacturer/operator/end-user of the system) for initial setting.

Anyway, Can I get Example Code about the function "Flash from Binary"?
Is it open source? and Is it available?

Reply for me.
Thank you.

over 4 years ago

0 Kedar_Sirdeshpande over 4 years ago

TI__Expert 3370 points

Hello Chankwook,

The "Flash from Binary" option in the GUI directly writes to the flash device on SPI using either on board FTDI or Aardvark adapter.

Based on the device used, you can use an adapter that can flash directly the binary that you generate using our GUI.

Regards,
Kedar

0 Chanwook An over 4 years ago in reply to Kedar_Sirdeshpande

Prodigy 240 points

Hello Kedar,

Thank you to reply for me.

Last question,

Can I get Example Code about the "Application Customization Tool"?
Is it open source? and Is it available?

0 Kedar_Sirdeshpande over 4 years ago in reply to Chanwook An

TI__Expert 3370 points

Hi Chanwook,

As mentioned before, you can use an Adapter like Aardvark to program the flash directly on the SPI lines. Aardvark is a 3rd party tool that our GUI interfaces with.

This tool comes with its own GUI also called "Flash Center".

Regards,
Kedar

Interface

Interface forum

TPS65987D: Example code for "Flash from Binary"