DS90UB935-Q1: Transmitter speed

hi,

for this case, the 953's input csi2 total data bandwidth should be less than 400Mbps x lane number.

regards,Steven

Hi Steven,

Thank you for your reply.

Does the DS90UB935 need configure the related registers? Do we just consider the input of DS90UB935?

Thanks.

Kevin Xiong

yes, you need set the csi2 port to make them alignment, such as lane number, continuous clock etc if these settings are NOT default.

Steven

Hi Steven,

Let me clarify this issue. The 954 sets tx speed as 400Mbps (the default value is 800Mbps). We don't change any register on 935 (let all registers of 935 as the default value) and just consider the 935's input signal. Then we can match this application. Is that right?

Thanks.

Kevin Xiong

Let me clarify this issue. The 954 sets tx speed as 400Mbps (the default value is 800Mbps). We don't change any register on 935 (let all registers of 935 as the default value) and just consider the 935's input signal. Then we can match this application. Is that right?

Let me clarify this issue. The 954 sets tx speed as 400Mbps (the default value is 800Mbps). We don't change any register on 935 (let all registers of 935 as the default value) and just consider the 935's input signal. Then we can match this application.