Hello,
What are the default values of the TPIC8101's SPI registers right after a device start-up? Since I cannot find them in the data sheet, are the values unknown?
Best regards,
Shinichi Yokota
This thread has been locked.
If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.
Hello,
What are the default values of the TPIC8101's SPI registers right after a device start-up? Since I cannot find them in the data sheet, are the values unknown?
Best regards,
Shinichi Yokota
Hello Yokota-San,
The datasheet has provided default values. Is there any information that is missing ?
Please let us know if this information helps!
Arjun-san,
Could you point out where it is in the data sheet? I'm afraid I can find it nowhere.
Best regards,
Shinichi Yokota
Arjun-san,
Do you mean this one? Although I marked the previous post with "This resolved my issue," I later noticed something wrong with it. The data sheet says on page 12 that in the default SPI mode, the SDO directly equals to the SDI (echo function). I guess the values under "Responses (t)" just echo the SDI code and are not the default values. My conclusion is, No default values are written in the data sheet. Please take a look, again.
Best regards,
Shinichi Yokota
Hello Yokota-San,
I understand. When you have clicked on Its resolved you can always respond to this.
I will need some time to get back to you here. I will have some feedback by next week.