DS90UB954-Q1: replicate mode on port1

Takuma Ito

hello, for replicate mode in 954, i can enable/disable the replicate on port1, but is it possible to enable/disable the port 0 while keeping the port 1 enabled? in other words, i want to set the port1 to master and port 0 to be replicate port.

over 5 years ago

0 Sally Cheung95 over 5 years ago

TI__Expert 5480 points

Hi Ito-san,

Can you please explain why you are trying to use the 954 in this way?

Thanks

Sally

0 Takuma Ito over 5 years ago in reply to Sally Cheung95

TI__Expert 5200 points

hi Sally,

My customer has already made a board and now they need to on/off the CSI2 port 0 but CSI2 port 1 kept enabled. To avoid revising the board, they dont want to change the PCB pattern. In my understanding they need to change the PCB pattern and swap the port 0 and port1 to do this, please tell me if my understanding is correct.

0 Sally Cheung95 over 5 years ago in reply to Takuma Ito

TI__Expert 5480 points

Hi Ito-san,

The DS90UB954 cannot do what you are asking. Perhaps they can have both ports running and only process data going in to the second port.

Thanks

Sally

Interface

Interface forum

DS90UB954-Q1: replicate mode on port1